Skip to Content
Module 2 Lesson 4

Xunda | Beginner Module 1: Xunda First Print

This lesson walks you through Beginner Project One: printing your first real object, a simple name tag. It explains why a name tag is the ideal first print, how to read the anatomy of a healthy first layer, and the four steps to actually run and share your print. Key topics covered: - Why the name tag is the ideal first project: fast, personal, observable - The anatomy of a healthy print: adhesion, clean edges, readability - A five-minute visual checklist of healthy signs vs. warning signs - Avoiding the 'rushing the basics' trap - Four steps to build: prepare, launch, observe, share

Knowledge Check

Answer the questions below to reinforce what you've learned.

1. What is "Project One," the print featured in Lesson 4?
A name tag A tool holder A phone stand A filament spool holder
2. Which of the following is one of the three reasons Lesson 4 gives for why a name tag is an ideal first project?
It requires heavy supports It's observable — its flat shape makes it a perfect test of your printer's baseline setup It uses the most filament of any beginner print It takes several hours to complete
3. According to the lesson's "equation," printing the name tag is a live test of which two things?
Nozzle temperature and print speed Retraction distance and cooling fan speed Bed leveling and Z-offset Layer height and infill percentage
4. When reading the "anatomy of a healthy first print," what should you inspect first?
Readability of the fine details The color consistency of the filament Clean edges around the perimeter Adhesion — the foundation
5. What does checking "adhesion" on your first print involve?
Checking whether the bottom layer is sticking firmly, without dragging, peeling, or sliding Checking whether the outer walls have any stringing Checking the total print time Checking whether the letters are legible
6. What does the "clean edges" check look for?
Whether the bed is level Outer walls printing neatly, with no stringing or messy gaps Whether the nozzle is clogged Whether the filament color matches the design
7. Which of the following is listed as a warning sign that means you should stop the print?
Lines that are even, flat, and well attached A pattern that is stable and consistent across the bed The layer looking overly squashed, thin, or see-through The print feeling solid enough to leave alone
8. What result does the "amateur mindset" of hitting print and walking away lead to, per Lesson 4?
Faster learning and reliability you can repeat Early problem detection A stronger structural foundation Missed warning signs, wasted filament, and later confusion
9. What result does the "maker mindset" of treating the print as a calibration test lead to?
Early problem detection, faster learning, and repeatable reliability Wasted filament Missed warning signs Confusion during complex prints
10. What are the four steps Lesson 4 gives for completing Project One?
Design, slice, print, sand Prepare, launch, observe, share Heat, level, print, cool Buy filament, calibrate, print, package
Get started